Hot Tub Guide

Please shower before using the hot tub To prevent cloudy water from lotions, oils, and dirt.

• Limit Soak Time: To avoid dehydration and overheating, please limit your time in the hot tub to 15-20 minutes; cool off before re-entry.
• Temperature Caution: Do not enter if water temperature is over 104°F (40°C).
• No Glass Containers: Do not bring glass in or near the Hot Tub.
• Children Supervision: Children must be supervised by an adult at all times.
• No Diving or Jumping: The hot tub is for soaking only. 
• No Alcohol or Drugs: Do not use the hot tub while under the influence of alcohol or drugs. 
• Respect Quiet Hours: Please respect the quiet hours when using the hot tub.
• Maximum Occupancy: Do not exceed the maximum occupancy limit 5 persons max.

After each soaking session, treat the Hot Tub water to ensure the water is always clean and clear for your next session. The hot tub chemicals are right next to the outdoor sink.   

While the Hot Tub Jets are on the LOW SETTING, Add to the Hot Tub Water: 

1. ADD Chemicals:

• 2 Capfuls of Oxidizer - Orange cap bottle 
• 2 Capfuls of Chlorine - Blue cap bottle

2. Keep the Hot Tub Cover OPEN for 10 minutes while the chemicals are working. 

3. CLOSE Hot Tub Cover to maintain water levels, temperature, and quality.

Now, the Hot Tub will be ready for your next soak!

Turn the Jets ON/OFF:

• Press the blue “Jets” button on the hot tub control panel to turn jets ON. 
• The jets run on a 15 min. timer and will automatically shut off. 
• Press the blue “Jets” button again to restart them.

Control the intensity of the Jets:

• Locate the 3 grey round knobs near the control panel.
• Turn clockwise or "righty-tighty" to set jets to LOW setting.
• Turn counter clockwise or "lefty-loosey" to set jets to HIGH setting.

Waterfall feature:

• Slide the knob right to turn ON waterfall.
• Slide the knob left to turn OFF waterfall.

Use the hot tub controls panel to adjust the water temperature. The recommended range is between 100°F and 103°F (37.8°C to 40°C).

• Press the Red thermometer plus (+) to make water temp. WARMER.
• Press the Blue thermometer minus (-) to make water temp. COOLER. 

Note: Depending on the temperature change, the hot tub may take an hour or two to reach the set temperature.

Turn the Hot Tub Lights ON/OFF:

• Press the blue “Lightbulb” button on the hot tub controls panel to turn lights ON. 

Change the Color of Hot Tub Lights:

• Pressing the blue “Lightbulb” button multiple times will cycle through the multi-color LED light feature. Stop when you find a color light you like!

• When you’re finished using the hot tub, lower water pressure of the hot tub jets and waterfall features.
• Replace the cover to keep the water clean and maintain the temperature.
• Secure the cover using the provided straps or locks to prevent it from blowing away in windy conditions.